Fishing with Rod Discussion Forum

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Attaching Snap to Braided Line on Downrigger  (Read 3273 times)

rootbeer

  • Full Member
  • ***
  • Offline Offline
  • Posts: 78
Attaching Snap to Braided Line on Downrigger
« on: August 31, 2012, 08:30:18 PM »
Recently switched to 150# braided line on the downrigger.  I notice now that the snap doesn't grab the braided line the same way it did the wire line and that the snap now slides up and down the line.  I'm not very familiar with downriggers and I don't know if this is a big deal or not, or what to do to fix it, if it is.  Any help would be greatly appreciated.   ???
Logged

ynot

  • Old Timer
  • *****
  • Offline Offline
  • Posts: 582
Re: Attaching Snap to Braided Line on Downrigger
« Reply #1 on: September 01, 2012, 04:17:59 PM »
The braided line is probably smaller diameter than steel line ,try bending the snap lever to make it tighter.
Logged

EZ_Rolling

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 398
Re: Attaching Snap to Braided Line on Downrigger
« Reply #2 on: September 01, 2012, 05:08:53 PM »
I also have this issue with the braid on my riggers.....anyone have a cure?
Logged

mikeyman

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 444
Re: Attaching Snap to Braided Line on Downrigger
« Reply #3 on: September 01, 2012, 09:32:34 PM »
When crimping your snap swivel to the bottom of the Braid, I tie a knot, and then leave a tail, then crimp the extra, if simply crimping the line, it will slip and you will lose your cannon ball, which sucks. If you are having problems with your clip sliding up and down, use a couple S clips top and bottom, clip in between. If you go to Nika or Berry's etc, they will show you what to use. Good luck out there, catch an orca.

Logged