Topic: Need Bar Rod Holder (Read 11006 times)

Fishbreath · « **Reply #15 on:** August 17, 2004, 07:06:29 PM »

I made one a while back using a 4ft piece of angle iron, 1.5ft of 3" diameter black abs pipe and 2 nut tightened band clamps. Take a hack saw and make two cuts on an angle to form a point on one end of the angle iron. Take the same hack saw and notch one end of the abs pipe. Fasten the abs pipe on the angle iron with the band clamps and you should have a sturdy rod holder. The notch in the abs pipe is for the seating of your reel so your rod and reel setup doesn't shift around in the abs pipe.

otto · « **Reply #16 on:** August 18, 2004, 10:00:27 PM »

otto · « **Reply #17 on:** August 19, 2004, 02:03:36 AM »

there seems to be a market for bar rod holders.....what length do you people prefer?

i may just start a sideline business.....

The Gilly · « **Reply #18 on:** August 19, 2004, 08:37:43 AM »

Hey dead head! Lets see your add in the B&S for rod holders. Two short welds and a point. Think of all the BB's you have to sell at 50c.-75c. to make up for 1 holder. Think of the jet boat you dream about. I'm going to make my own if you're not fast enough

dead head · « **Reply #19 on:** August 19, 2004, 07:15:36 PM »

ya ok I can makem send your design to me I will build it

for a great price....I can build ya steel or alum

dead head · « **Reply #20 on:** August 19, 2004, 07:18:15 PM »

I will beat everybodys price lol

Author Topic: Need Bar Rod Holder (Read 11006 times)

Fishbreath

Re:Need Bar Rod Holder

otto

Re:Need Bar Rod Holder

otto

Re:Need Bar Rod Holder

The Gilly

Re:Need Bar Rod Holder

dead head

Re:Need Bar Rod Holder

dead head

Re:Need Bar Rod Holder